Ranger RWS-1B Installation And Operation Manual

Bubble balancer

Download this manual

INSTALLATION AND OPERATION MANUAL

BUBBLE BALANCER

MODEL: RWS-1B

SHIPPING DAMAGE CLAIMS

When this equipment is shipped, title passes to the

purchaser upon receipt from the carrier. Consequently,

claims for the material damaged in shipment must be

made by the purchaser against the transportation

company at the time shipment is received.

PLEASE READ THE ENTIRE CONTENTS OF THIS MANUAL PRIOR TO

INSTALLATION AND OPERATION. BY PROCEEDING YOU AGREE THAT

YOU FULLY UNDERSTAND AND COMPREHEND THE FULL CONTENTS OF

THIS MANUAL. FORWARD THIS MANUAL TO ALL OPERATORS. FAILURE TO

OPERATE THIS EQUIPMENT AS DIRECTED MAY CAUSE INJURY OR DEATH.

BE SAFE

Your new Bubble Balancer was designed and built

with safety in mind. However, your overall safety

can be increased by proper training and thoughtful

operation on the part of the operator.

DO NOT operate or repair this equipment without

reading this manual and the important safety

instructions shown inside.

Manual Revision A1 - May 2020

Manual Part Number 5900229

Keep this operation manual near the

machine at all times. Make sure that

ALL USERS read this manual.

1645 Lemonwood Dr.

Santa Paula, CA. 93060, USA

Toll Free 1-800-253-2363

www.rangerproducts.com

Tel: 1-805-933-9970

Fax: 1-805-933-9160

Page 1 OPERATE THIS EQUIPMENT AS DIRECTED MAY CAUSE INJURY OR DEATH. Manual Revision A1 - May 2020 Manual Part Number 5900229 INSTALLATION AND OPERATION MANUAL BUBBLE BALANCER MODEL: RWS-1B Keep this operation manual near the machine at all times. Make sure that ALL USERS read this manual. SHIPPING DAMAGE CLAIMS...
Page 2 Defective parts replaced at no charge must be returned to your dealer or Ranger Products™ within 60 days of the date that the replacement parts are shipped; otherwise, you must pay for the replacement parts at the current selling price.
Page 3: Tools Required
TOOLS REQUIRED 5. Remove the tire/wheel assembly from the Balancer and place the proper amount of weight needed on both sides of the rim. For example, it the required weight is 3 Adjustable Wrench or Metric open end/combination ounces to balance the wheel, attach an 1.5 ounce weight wrenches, phillips head screwdriver.
Page 4 Shipping Weight: 12.5 lbs; (5.6 kgs) Calibrated @ 90º, 180º, 270º & 360º For additional copies or further information, contact: BendPak Inc. / Ranger Products 1645 Lemonwood Dr., Santa Paula, CA. 93060 1-805-933-9970 www.bendpak.com www.rangerproducts.com 5. Remove the two pairs of weights and lift the tire from the balancer.