Table of Contents
Advertisement
REMOVING FRONT SCREEN
1) Remove the two(2) screws and lift the front screen slightly up. (Fig. 7A) Then tilt the bottom of the screen
inward and downward. (Fig. 7B) 2) Lean the top of the screen toward you slightly (Fig. 7B) and then
proceed to carefully bring the screen straight back (Fig. 7C). NOTE: To reinstall the front screen, reverse
steps 1 & 2.
FIG 7A
LOG ASSEMBLY
LOG POSITIONING
Do not handle these logs with your bare hands! Always wear gloves to prevent skin irritation from ceramic fibers.
After handling logs, wash your hands gently with soap and water to remove any traces of fibers.
PROPER INSTALLATION SEQUENCE:
WARNING: Failure to position the
parts in accordance with these dia-
grams or failure to use only parts
specifically approved with this heater
may result in property damage or
personal injury.
FIGURE 8. Log Set Assembly
The positioning of the logs is critical to the safe and clean operation of this heater.
Sooting and other problems may result if the logs are not properly and firmly
situated in the appliance. Never add additional logs or embellishments such as
pine cones, vermiculite or rock wool to the heater.
FIG 7B
11
FIG 7C
Hide quick links:
Advertisement
Table of Contents
