Safety Features; Cleaning And Storage; Troubleshooting - Honeywell Energy Smart CoolTouch HZ-7200 Series Manual

OPERATION (continued)
To set the heater, the digital control is equipped with two
(2) modes: (See Fig. 2)
Constant Heat Mode - Choose from two (2) heat settings:
1. Constant Low, press SET to LO ( ); this setting uses 900 watts
of power
2. Constant High, press SET to HI ( ); this setting uses 1500 watts
of power
NOTE: Because the Low setting does not require as much electricity
to operate, it is more energy efficient and may be a better option if
you are concerned about saving energy.
EnergySmart™ Mode - A smart thermostat that helps you
save energy. Press SET to choose four (4) comfort settings of
65°F (18°C), 70°F (21°C), 75°F (24°C), 80°F (27°C). This is

SAFETY FEATURES

This EnergySmart® Cool Touch Heater is equipped with several devices and features for added protection:
- This heater was crafted using a high quality safety plastic which allows for the "Cool Touch" exterior. If the heater grille is
touched briefly, it will not cause a burn. For safe operation, do not continuously hold bare skin against the grille..
• Tip over protection – a tip-over switch that disables the heater if it is accidentally tipped over.
• A high temperature safety control prevents overheating.
• Thermal cut-off fuse that will permanently shut down the heater should it operate at a higher than normal temperature.

CLEANING AND STORAGE

It is recommended that the heater be cleaned at least once a month and before off-season storage. Save the carton for off-season storage.
• Turn the heater OFF ( ) and unplug it. Allow it to cool.
• Use a dry cloth to clean only the external surfaces of the heater. DO NOT USE WATER, WAX, POLISH OR ANY CHEMICAL SOLUTION.
• Before storing, clean the EnergySmart® Cool Touch Heater using the above-mentioned steps. Wrap the cord around its cord wrap
underneath the heater base. Pack the heater in its original carton and store it in a cool, dry place.

TROUBLESHOOTING

If your heater shuts off unexpectedly or fails to operate, one of your heater safety features may have been activated to prevent overheating.
• Be sure it is plugged in and that the electrical outlet is working.
• Check your EnergySmart® Thermostat setting. The unit may simply be off because you have reached your desired heat setting.
• Check for any obstructions. If you find an obstruction, turn the heater OFF and unplug it. Allow the heater to cool completely,
then remove the obstruction. Wait at least 10 minutes, then re-plug the heater in and follow the OPERATION instructions.
NOTE: IF YOU EXPERIENCE A PROBLEM, PLEASE CONTACT CONSUMER RELATIONS FIRST OR SEE YOUR WARRANTY. DO
NOT RETURN THE HEATER TO THE ORIGINAL PLACE OF PURCHASE. DO NOT ATTEMPT TO OPEN THE MOTOR HOUSING
YOURSELF, DOING SO MAY VOID YOUR WARRANTY AND CAUSE DAMAGE TO THE PRODUCT OR PERSONAL INJURY.
4
your desired room temperature. The EnergySmart® thermostat
will automatically select the appropriate power level to best
accommodate your Desired Temperature. As the air temperature
(Current Temp) in the room approaches the Desired Temperature,
the heater will automatically lower the power consumption to
provide consistent warmth without wasting energy.
The Current Temp Indicator will display the current room
temperature.
In the EnergySmart® mode, the Energy Usage Indicator will display
what power consumption the heater has automatically selected to
efficiently meet your Desired Temperature.
To override the EnergySmart® function, turn the heater OFF ( ) or
press SET to choose a Constant Heat mode.