Daikin D Series Service Manual page 116

SiBE12-519
■ To use ON TIMER operation
• Check that the clock is correct. If not, set
the clock to the present time.
1. Press "ON TIMER button".
is displayed.
blinks.
2. Press "TIMER Setting button"
until the time setting reaches
the point you like.
• Every pressing of either button
increases or decreases the time setting
by 10 minutes. Holding down either but-
ton changes the setting rapidly.
3. Press "ON TIMER button"
again.
• The TIMER lamp lights up.
ON
OFF
■ To cancel ON TIMER
operation
4. Press "CANCEL button".
• The TIMER lamp goes off.
■ To combine ON TIMER and OFF TIMER
• A sample setting for combining the two timers is shown below.
(Example)
Present time: 11:00 PM
(The unit operating)
OFF TIMER at 0:00 a.m.
ON TIMER at 7:00 a.m.
ATTENTION
■ ■ ■ ■ In the following cases, set the timer again.
• After a breaker has turned OFF.
• After a power failure.
• After replacing batteries in the remote controller.
System Configuration
HOME LEAVE
POWERFUL
MODE
SILENT
Combined
C
ON/OFF
TEMP
FAN SWING
SENSOR
ON CANCEL
OFF
TIMER
Instruction
1.3
4
2
107