Step 3 - Handle Installation - Kalia GRAFIK BF1292 Installation Instructions / Warranty

Table of Contents

Advertisement

Étape 3 - Installation de la manette
fig. 3.1
Dévisser le boulon de fixation et retirer le joint d'étanchéité
et la plaque de métal en C. Laisser le joint d'étanchéité de la
manette sur le corps de la manette.
Insérer le corps de la manette à travers le trou prévu à cette fin
par le dessus du bain (fig. 3.1).
Remettre le joint d'étanchéité et la plaque de métal en C en
fig. 3.2
position. Centrer la manette sur le trou. Fixer en position en
vissant le boulon de fixation (fig. 3.2).

Step 3 - Handle Installation

Unscrew the mounting nut and remove the C-type rubber
gasket and metal plate. Keep the handle base gasket on the
handle body.
Insert the handle body through the hole by the top (fig. 3.1).
Install the C-type rubber gasket and metal plate back on the
handle body. Center the handle on the hole. Fix in position by
screwing the mounting nut (fig. 3.2).
Étape 4 - Installation de la douchette
Insérer le tube fileté de la base de la douchette dans le trou
fig. 4.2
prévu à cette fin (fig. 4.1). Aligner correctement la base de
fig. 4.1
la douchette et fixer en position en vissant l'écrou de retenue
et les rondelles. Resserrer l'écrou à l'aide des vis (fig. 4.2).
Assurez-vous d'avoir en place les 2 rondelles de caoutchouc
(à chaque extrémité) du boyau de la douchette (fig. 4.1).
Passer le boyau de la douchette dans le tube de la base de la
douchette par le dessus. Visser la douchette à l'extrémité du boyau.
Visser le boyau à la sortie du raccord et l'extrémité du boyau
de la douchette au boyau (fig. 4.1).
Step 4 - Handshower Installation
Install the handshower base threaded tube in the hole (fig.
4.1). Correctly align the handshower base and fix in position
by screwing the retainer nut and washers on the threaded
tube. Tighten the retainer nut screws (fig. 4.2). Make sure to
have both rubber washers at each end of the hand shower
hose (fig. 4.1).
Insert the hand shower hose through the hand shower base
threaded tube by the top. Screw the hand shower to the hose (fig. 4.1).
Connect the hose to the outlet of the connector and the hand
shower hose to the hose (fig. 4.1).
7

Advertisement

Table of Contents
loading

Table of Contents