Controls And Functions - Uniden Bearcat UBC760XLT Owner's Manual

,(,Qqt"QI~~.a;
d<F'unqions
unIden
~
VOL
-!)-
SOL
BANK
"34'
,,-,/-, /_"~'-'/-'~IC
, L' L' I ,_, '-'.I-' '- -'
PR' L/Q Oli cOlT HLD se. SRC
Off
I
CD CV
@ @ @
1. On/Off, Volume - Turns the unit
on or off, and controls the audio
output level.
2. Squelch - Eliminates the annoying
"rushing" sound that is present be-
tween transmissions when no sig-
nal is being received. Proper adjust-
ment of this control keeps the re-
ceiver quiet and allows scanning
until a signal is received.
3. Scan - Press to start scanning all fre-
quencies programmed into memory
that are not locked out.
4. Manual - Press to stop scanning.
Press again to manually step to the
next channel. Press the channel
number and then press the manual
key to go directly to that channel.
Priority
-
The priority key samples
channel 1 every two seconds re-
gardless of other operational set-
tings.
~~~-~~~~ ~---
~_m__~~~~---
10.Search - Press to search for new ac-
tive frequencies within preset
ranges of any band.
11.Lockout/Clear - Press to lockout
the reception of frequencies on se-
lected channels during scanning.
Lockout is retained in memory.
Press again to deselect lockout.
Pressing the lockout for 2.5 seconds
will clear all the locked out frequen-
CIes.
12.Numeric Keypad - ("0-9" and "."J
Used to program all frequencies in-
to memory and for direct channel
access. During the scan mode these
keys are utilized to se'lect or deselect
any of the 5 memory banks.
13.Enter - The "E"key is used to enter
frequencies into the scanning
memory.
@
@
I
@ W@ @@@
6. Hold - Press to stop and hold the
search function on the current fre-
quency. Press again to manually
step up to the preceding frequency.
7. Loop Function - Program 5 fre-
quency bands L1 to L5.
To program these frequency bands
it is only necessary to input an up-
per frequency and a lower frequen-
cy to specify a search range within
one band.
8. Delay - The delay key provides a 2
second delay on any channel to re-
ceive a reply transmission on the
same frequency before resuming
search or scan. Delay is retained in
memory.
9. Limit - Enter the Iow and high li-
mits of the search range. Press to
manually step the search frequency
down.
(@)
14.Memory Lock - This unique fea-
ture is used to lock the keypad to
prevent accidental entries and is lo-
cated on the back panel.
15.External Speaker - The external
speaker jack allows you to use an
alternate speaker in case of a high
noise environment. Use Uniden
model ESP 25 external speaker for
best results.
16.Tape Out - Thisjack allows you to
connect to any standard tape recor-
der in order to record transmissions.
OFAON
MEMO. LOCK
~
T DC 138 V
@ @@