Korg StageVintage SV-2 Midi Implementation Manual page 5

3. APPENDIX
3-1. NOTES
*1 : kk range = (28-100) for 73-keys model
= (21-108) for 88-keys model
*2 : See TABLE 1 and TABLE 2 for Bank and Program numbers of Factory and Favorite Sounds.
*3 : Only transmitted by the "MIDI Panic" function.
Concerning the Registered Parameter Numbers (RPN), the values sent when "MIDI Panic" is performed
are the reset values for the following registered parameters:
r = 0 : Pitch Bend Sensitivity
= 1 : Fine Tune (Detune)
= 2 : Coarse Tune (Transpose)
= 5 : Modulation depth range
*4 : Function of a pedal plugged into the "Pedal 2" input:
If the pedal is a "switch"-type pedal, it works as a Soft controller.
If the pedal is a "continuous"-type of pedal, it controls Expression, unless PRE_FX is enabled and set
to "VOX Wah", in which case the pedal works as a Breath controller.
*5 : Polyphonic After Touch and Channel Pressure work only on those programs where these parameters are ena-
bled.
*6 : If the Wah effect is selected and Auto/Pedal is ON, the Breath controls the filter.
*7 : Bank Select (MSB) values others than indicated in TABLE 1 and TABLE 2 are ignored.
*8 : If the Rotary effect is selected, Sostenuto controls the rotor's speed.
*9 : Recognized parameter numbers (r) are:
+----------------------+------------------------------------------------------------+
| Parameter number (r) |
+----------------------+------------------------------------------------------------+
| 1
| 2
+----------------------+------------------------------------------------------------+
*10: SV-2 performs Local Control On/Off, regardless of the SV-2 MIDI channel
*11: SV-2 implements only Omni Off/Poly mode.
Reception of different modes act as if it has received "All Notes Off" mode message.
| Fine Tune (Detune)
| Coarse Tune (Transpose)
Description
5
|
|
|