Scanning The Stored Channels - Uniden BEARCAT BC95XLT User Manual

press Func +
frequencies.
To release the hold and continue searching, press
Hold. Or, if you did not press Hold, simply press
Func +
Note: Because there are many different frequencies
allocated to fire and police departments, it can take
several minutes to search all the service frequencies.
Storing Frequencies into Channels
During Service Search
You can store frequencies you found during service
search or service search hold mode into channels.
1. Press Func and Pgm during service search or
service search hold mode. The frequency and
the lowest blank channel alternately appear.
2. Press E to store the frequency into the blank
channel. If you want to select another channel,
press Func +
E. You can also use the 0-9 key to select the
bank.
If you entered a frequency that has already been
entered elsewhere, the scanner sounds an error
tone and displays the channel that was duplicated.
If you entered the frequency by mistake, press
then enter the correct frequency. To enter the
frequency anyway, press E to accept.

Scanning the Stored Channels

To begin scanning channels, press Scan.
The scanner scans through all non-locked channels
in the activated banks. (See "Locking Out Channels"
on Page 49 and "Turning Channel-Storage Banks
On and Off" on Page 48). When the scanner finds a
or Func +
or Func +
or Func +
to step through the
to continue searching.
before you press
35
Operation