Programming From Scan Mode - Uniden BC 350C Owner's Manual

UB317Z (BC350C) 0916

Programming from SCAN Mode:

When you find an interesting active police frequency while
scanning, and want to program it into the private bank (see
"Scanning" on page 19) to monitor their communications:
9/16/03 12:43 PM
1. Press [HOLD].
"HOLD" appears on the
display.
2. Press [PROG]. CH appears
and blinks to indicate that you
are in the Programming Mode.
To change the displayed fre-
quency, use [UP] or [DOWN]
while "CH" is blinking.
3. Press [PRIVATE]. "PRIVATE"
appears on the display.
If you want to program it into
another bank, press the
desired bank key. The lowest
open channel appears on the
display.
2 screens alternate to indicate
that open channel is available
to be programmed.
The scanner automatically
selects the lowest open
channel (000.0000) for easy
programming. If all channels
have been programmed (there
are no open channels in the
bank), channel 1 appears.
Use [UP] or [DOWN] to select
a new channel and even over-
write old channels.
4. Press [PROG] to store the
frequency in the desired
channel.
Note: Press [BAND] to escape
from programming mode before
step 4.
25
Page 25