Table of Contents
Advertisement
Using
the AutoStandby Feature
When you finish
a call and place the Handset back on the Base Unit,
AutoStandbyautomatically hangs up the phone. There is no need to press
TALK
to hang up.
NOTE: If you don't place the Handset back on the Base Unit, you need
to press TALKto hang up the phone.
NOTE: Sometimes when you press TALKto hang up the phone, you may
get an error tone and the phone will not disconnect. This may
occur during conversations under
noisy
conditions. If this
happens, place the Handset back on the Base Unit, or press
TALKagain while holding the Handset close to the Base Unit
Storing a Number
To store a number in memory:
1. Remove the Handset and press MEM.(Do not press TALK.)You will hear
a beep indicating the unit is ready to be programmed.
2. Enter the number (up to 16 digits) you want to store.
3. If you wish to enter a delay between numbers (for accessing a
switchboard, o r longdistanceservice),press
ROUP at the point in the
number sequence you wish to pause.
(Note:
The ROUP button counts as
one
digit)
Pressing ROUPmore than once will increase the length of the
pause between numbers.
4. Press MEM and a number (01-20) for the memory location you wish to
use.
You will hear a long beep when the number you have entered has been
successfully stored.
NOTE: You have 20 seconds after pressing MEMto enter the number you
wish to store. Otherwise, an error tone will sound.
5. Write the stored number and its memory location number on one of the
enclosed stickers so you won't forget them.
Storing
a
Mixed
Tone/Pulse Number Witha Pulse
Dial
System (available on Australian Models only)
If you've set up your XC 310 for Pulse Dialing, you can store a mixed mode
number to make it easy to access long distance services. To store a mixed
mode number (up to 16 digits):
1. Press MEM.(Do not press TALK.)You will hear a beep indicating the unit
is ready to be programmed.
17
Advertisement
Table of Contents
