Setting The Power On/Off Switch; Setting The Dialing Mode - Uniden XC-360 Operating Manual

Also, check the charging contacts
on the handset and base. If the
contacts are dirty or tarnished,
clean them with a pencil eraser.
.
A full charge lasts about one day
with the handset on in the standby
mode. Be sure to return the hand-
set to the base when you see the
BATTLOW indicator light.
. After the first charging, you should
recharge the handset's battery 2
hours for every 1 hour of use.
.
ABOUT ONCE A MONTH, FULLY
DISCHARGE THE BATTERY.
OTHERWISE, THE BATTERY
LOSES ITS ABILITY TO FULLY
RECHARGE, AND YOU WILL
HAVE TO RECHARGE AND RE-
PLACE IT MORE OFTEN.
TO FULLY DISCHARGE THE BAT-
TERY, KEEP THE HANDSET OFF
THE CRADLE UNTIL THE BATT
LOW INDICATOR COMES ON.
THEN, SET POWER ON/OFF TO
OFF, RETURN THE HANDSET TO
THE CRADLE, AND FULLY
RECHARGE THE BATTERY.
SETTING THE POWER
ON/OFF SWITCH
If you keep the handset away from
the base for several hours, set the
6
handset's POWER ON/OFF switch to
OFF to preserve battery power. This
ensures a sufficiently charged battery
when you make or answer a call. Turn
on the handset before you make a
call or when you hear another exten-
sion phone ring.
SETTING THE DIALING
MODE
Set TONE/PULSE for the type of ser-
vice you have. If you are not sure
which type of service you have;
1. Set TONE/PULSEto PULSE. This
will make the phone operate on ei-
ther a tone or pulse line.
2. Contact Telecom to see if your
phone line is a tone line.
3. If it is then switch your phone to
tone.
4. If not then leave your phone on
pulse dialing.