Kia Sportage 2008 Manual page 195

7/6/12 https://www.kiatechinfo.com/viewer/toc_print.asp?vehicletype=Passenger&mfrcode=KM&area=KM...
Inspection Procedure
1. PREPARATION
(1) Turn the ignition switch to LOCK.
(2) Disconnect the negative (­) terminal from the battery and wait for at least 3 minutes.
(3) Remove the DAB module and disconnect the DAB connector.
(4) Disconnect the connectors of the PAB, SAB, CAB, BPT, BUPT, FIS and SIS.
(5) Disconnect the SRSCM connector.
2. CHECK OPEN CIRCUIT
(1) Measure resistance between the terminal 4 of OC module harness connector and the terminal 44 of SRSCM
harness connector.
(2) Measure resistance between the terminal 5 of OC module harness connector and the terminal 43 of SRSCM
harness connector.
specification(resistance) : below 1 Ω
(3) Is the measured resistance within specification?
► Check short to ground.
► Repair the open circuit on wiring harness between the OC module and the SRSCM.
3. CHECK SHORT TO GROUND
(1) Measure resistance between the terminal 4 of OC module harness connector and chassis ground.
specification(resistance) : infinite
(2) Is the measured resistance within specification?
► Check short circuit.
► Repair or replace the wiring harness between the OC module and the SRSCM.
4. CHECK SHORT CIRCUIT
(1) Measure resistance between the terminal 4 and 5 OC module harness connector.
https://www.kiatechinfo.com/viewer/toc_print.asp?vehicletype=Passenger&mfrcode=KM&area=KM... 195/227