Terminal Equipment; Radio Equipment - Uniden DCX 520 Owner's Manual

To playback a message
To skip a message
To repeat the current message Press the
To repeat the previous message Press the
To delete a message
To stop operation
• If you press end before the answering system answers, the
phone will return to the standby mode.
• When the answering system does not answer within 6 seconds,
you will hear a beep and the phone will return to the
standby mode.
• When you receive a call, the remote operation is canceled.
I.C. Notice

TERMINAL EQUIPMENT

NOTICE: This equipment meets the applicable Industry Canada
Terminal Equipment Technical Specifications. This is confirmed by
the registration number. The abbreviation, IC, before the
registration number signifies that registration was performed based
on a Declaration of Conformity indicating that Industry Canada
technical specifications were met. It does not imply that Industry
Canada approved the equipment.
NOTICE: The Ringer Equivalence Number (REN) for this terminal
equipment is marked on the equipment itself. The REN assigned to
each terminal equipment provides an indication of the maximum
number of terminals allowed to be connected to a telephone interface.
The termination on an interface may consist of any combination of
devices subject only to the requirement that the sum of the Ringer
Equivalence Numbers of all the devices does not exceed five.

RADIO EQUIPMENT

The term "IC:" before the radio certification number only signifies
that Industry Canada technical specifications were met.
Operation is subject to the following two conditions: (1) this device
may not cause interference, and (2) this device must accept any
interference, including interference that may cause undesired
operation of the device. "Privacy of communications may not be
ensured when using this telephone".
Press the
Press the
Press the DELETE soft key.
Press end.
– 6 –
soft key.
soft key.
soft key after four seconds.
soft key within four seconds.