Self Diagnostic Function; Setting Of Self Diagnostic Function - Panasonic SC-EN17P Service Manual

10 Self Diagnostic Function

10.1. Setting of self diagnostic Function

10.1.1. Setting of self diagnostic mode
1. To enter into self-diagnostic mode:
· Press & hold VOL+ key,followed by
2. LCD will show the following display as below:
3. Error during Test:
· Press & hold
displayed.
Example:
NOTE: Refer to error code table 11.1.
10.1.2. Test Mode Checking
1. Operation keys and all segment display check mode:
· Activate the Self Diagnosis mode before performing the following steps
· Press & hold REMORT CONTROL 2 key (>2 sec) will enter this mode.
· When the keys of the main set is pressed, the various corresponding key functions shall light up and display that particular
function. After all the main set keys were pressed, the LCD shows the following (Including CD LED):
2. CD lid OPEN/CLOSE aging test mode:
· Press & hold
· This mode counts the number of times the CD lid open/close (MAX is 65535).
− − − − <OPEN>:
− − − − <CLOSE>:
3. CD unit (250Z) and CD lid reliability test mode (Combination)
· Press & hold REMOTE CONTROL
key for more than 2 seconds.
(LCD Display)
key (> 2sec) will show blinking error code. If abnormality occurs during test, error code will be
key (>5 sec) will enter this mode.
→1→0key (>2 sec) will enter into this test mode.
17
SC-EN17P / SC-EN17PC