Installation; Preparation Of The Table; Preparation For The Steel Stand; Installation Of The Motor - Mitsubishi PLK-E1008H Technical Manual

3. INSTALLATION

Caution
The machine should be installed by the specialists who have enough experience for the
sewing machine installations.
All the necessary electric wiring should be done by electric engineers who are qualified for the
electric wiring.
If any damage or fault is found on the machine at the installation, please do not operate until it
is repaired.
Please do not operate the sewing machine with excessive modifications from the standard
specification

3-1 Preparation of the table

If the table is not MITSUBISHI original, the thickness of the table is required to have 40mm more.
And please refer to the cut out table drawing for your own preparation.
The cut out drawing is shown on the last page of this technical manual as APPENDIX 5 drawing.

3-2 Preparation for the steel stand

If the steel stand is not MITSUBISHI original, please refer to the assembling drawing for your own
preparation.
The assembling drawing is shown on the last page of this technical manual as APPENDIX 5
drawing.
If the steel stand is MITSUBISHI original, please assemble the steel stand with the assembling
instructions enclosed in the packing.

3-3 Installation of the motor

If the motor is purchased without assembling to the table, the motor has to be installed
underneath the table.
Please install the motor with the instructions explained in the paragraph [installation of the motor]
on the another [CONTROL UNIT] technical manual.

3-4 Installation of the control box

If the control box is purchased without assembling to the table, the control box has to be installed
underneath the table.
Please install the control box with the instruction in the paragraph [installation of the control box]
on the another [CONTROL UNIT] technical manual.

3-5 Connection of the teaching panel

Please install the operation panel referring following figure of control box backside view.
3