Related Manuals for Ricoh SC-10A
Summary of Contents for Ricoh SC-10A
- Page 1 Electric screwdriver Work Assistance Camera System RICOH SC-10A Connection to electric screwdriver Setting example 2020/6/26...
-
Page 2: Operation Flow
Check mode allow to input electric signal from screwdriver as OK signal using external I/O. Matching mode allow to confirm that the screw is firmly in the proper place. ※The SC-10A can receive the electric signal from the electric screwdriver. 2020/6/26 But information such as numerical data cannot be received. - Page 3 Configuration [Input] Check if the screw is completely tightened. [Output] Power is supplied to the screwdriver. Controller 2020/6/26...
-
Page 4: Wiring Connection
Wiring connection ▪ External connector on the body Connect to Electric screw driver and external power supply as follows; PIN9 ［ IN1 ］ → EXTIN PIN11 ［ I/O power ］ → 5V~24V±10% PIN12 ［ I/O GND ］ → I/O GND ※If the AC adapter is not directly connected to the main body, supply power from pin1 and 2. - Page 5 Cable connection between required PIN and external device ▪ Precondition ・ When using external I/O control, I/O power supply (11 and 12 pins) is required in addition to the main body power supply. ・ When using the AC adapter, do not connect the power supply for the main unit (pins 1 and 2) ※Please refer to page 14 and 26 of Operating...
-
Page 6: Setting Example
Setting example 2020/6/26... - Page 7 Operation flow Setting example of the process of tightening the screw in the order of ① to ④. Item１：Check mode Item３： Check mode Item５： Check mode Item７： Check mode ① ② ④ ③ ① ② Completion signal from electric screwdriver →...
-
Page 8: External Input
External input ▪ Setting external input ※Please refer to page 73 of Operating Instructions. 1. Click [External I/O Settings...] in the [System] menu. The [External I/O Settings] screen appears. ※Please refer to page 33 of Operating Instructions. When the external signal inputs correctly, Low and High light Select “EXTIN”... - Page 9 Work setting ① 1. Click the Job ID below [Job ID] in the Settings menu of the [Settings] screen. 2. Select a work instruction from [Instruction Steps]. 3. Click [Add] of [Inspection Steps]. ※Please refer to page 45 of Operating Instructions.
- Page 10 Work setting ② 4. Select a work mode from the pull-down list of [Select Mode]. ※Please refer to page 45 of Operating Instructions. Select “Check”...
- Page 11 Work setting ③ 5. Check mode parameters Set OK as EXTIN1 to input the signal from electric driver. Set Timeout, OK, and fail operation in [Judgment Conditions]. ※Please refer to page 54 of Operating Instructions. If necessary Select “EXTIN” for OK...
- Page 12 Work setting ④ 6. Click [Add] of [Inspection Steps], and create “Item2”. ※Please refer to page 45 of Operating Instructions. 7. Set the matching mode to check if the screw is located correctly. → the presence or absence of screws in matching mode in item2. Set the checkpoint Select “Matching”...