Advertisement
2. REPLACEMENT PROCEDURE
2.1 PREPARATION
The following facilities and tools are required.
(1) Finger stalls (glove)
(2) Grounding band (earth band)
(3) Workbench which is covered with conductive mat (workbench equipped to be prevent static
charges can be used)
(4) Replacing parts
LCD Module
NL10276BC13-01C
2.2 REGARDING THE LAMP HOLDER SET
(1) One set consists of two holders, one is for upper side and another is for lower side.
Confirm the upper side and the lower side of the lamp holders by referring to lamp holder
specification in advance.
(2) Don't put the upper holder in lower side or the lower holder in upper side and put in by force.
(3) To prevent the luminance un-uniformity, replace the both sides of the lamp holder. The
replacement of the one side causes the luminance un-uniformity.
Lamp holder set
65LHS13
DOD-PP-0404 (1st edition)
3
Advertisement
