Cisco Headset 500 Series Manual page 34

Remove a Bluetooth Headset
Step 3
Select a Bluetooth headset.
Step 4 Press Disconnect.
Remove a Bluetooth Headset
Remove your Bluetooth headset if you aren't going to use it with your phone again.
Procedure
Step 1 Press Applications
Step 2
Select Bluetooth.
Step 3 Select a Bluetooth headset and press Delete.
Set Up a Wideband Standard Headset
You can use a headset that supports wideband audio. Wideband audio improves the quality of the sound you
hear in the headset.
Procedure
Step 1 Press Applications
Step 2
Select Accessories > Analog headset > Setup.
Step 3 Press On or Off to enable or disable wideband for the analog headset.
Step 4 Press Return .
Enable Electronic Hookswitch Control on Your Phone
If your administrator has enabled Admin settings on your Cisco IP Phone, you can enable or disable electronic
hookswitch control to connect with a Cisco Headset 560 Series base. Electronic hookswitch control is enabled
by default.
Note This feature is available on Cisco IP Phone Firmware Release 12.7(1) and later.
Procedure
Step 1
On your phone, press Applications
Headsets
34
.
.
.
Headsets