Haier MRV 5-RC VP1-112B Service Manual page 72

Outdoor unit installation
Standard accessories
Please check the attachment is complete, please be sure to use.
No. definition
Installation
1
instruction
Rubber
4
plug
5 sheath
(8HP)
Reducing
6
pipe
wiring
7
harness
8 Wrench
1. Choose a place that can carry the weight of the unit to install and fix, so that the unit will not shake or fall. The
unit shall be installed in a flat area (below 1/100).
2. Do not install the unit in the areas where there may be flammable, explosive, corrosive gas leakage.
3. Indoor and outdoor machines should be close to each other as much as possible to reduce the length of the
refrigerant pipeline and the number of bends.
4. The installation should be to ensure that units from the sun and rain, dust, typhoon, earthquake proof place.
In the area of snow, the machine should be installed in the frame or under the snow cover, so as to avoid the
machine snow. See Figure 1
5. Make sure that there is enough room for maintenance
6. Measures should be taken to avoid contact with children
7. The refrigerant pipe by the unit below should be used when the overhead, overhead part height 200mm above.
See Figure 2
Snow cover (customer buy)
Wind shield (the customer at
his own expanse)
Seasonal wind
The base height should be
considered the maximum
snowfall locally, Prevent snow
height exceeds the unit angle.
Figure 1
Graphic
(10HP) (12~14HP)
2 2
2 2
2 1
Please use M12 fixed ancher bolts, each machine 4, and use
shock absorbers or cusions to reduce noise
69
Quantity Remarks
1
Signal line
1
protection
Power line
1
protection
(16~22HP)
1
2
Reducing pipe
1
Gas liquid pipe
4
insulation binding
Remove service
1
panel
Figure 2
Place
position
Accessory
bag
Accessory
bag
Accessory
bag
Accessory
bag
Accessory
bag
The outdoor
machine foot
beam
Aerial part
height above
200mm