Samsung RS68N Series Service Manual page 64

This document cannot be used without Samsung's authorization
PRECAUTIONS(SAFETY WARNINGS)
■ Water filter replacement (applicable models only)
CAUTION
• Do not use third-party water filters. Use only Samsung-provided or -approved filters.
• Unapproved filters may leak and damage the refrigerator, causing electric shock.
Samsung holds no responsibility for any damage that may occur from use of third party water filters.
• The filter indicator turns red as a reminder that lets you know it is time to replace the water filter.
NOTE
• A newly installed filter may cause the water dispenser to spurt water briefly. This is because air has
entered the water line.
• This replacement process may involve the refrigerator to drip water onto the floor. If this happens, wipe
up with dry cloths.
1. Shut off the main water supply.
2. Connect the water supply line to the inlet side of
the filter to the end.
3. Connect the dispenser line to the outlet side of
the filter.
4. Check if there is any leak. If not, fix the lines with
the clips.
5. Put the water filter into place and fix it with the
clips.
6. Press and hold Filter Reset for 3 seconds to reset
the filter lifecycle.
7. When replacing is complete, flush 10 litres of
water (or dispense the water for 6 - 7 minutes) to
remove impurities from the water line.
CAUTION
When adjusting the length of the water line tubing, make
sure to smooth out the cut surface at a right angle.
This is to prevent a water leak.
64