Table of Contents
Advertisement
Information messages
When activating the data connection from the menu, these messages are possible:
Opening...
The mobile terminal is currently opening the data connection.
Already Open
The data connection is already open.
Not Attached
The mobile terminal is not attached to the network.
No TE Found
There is no TE currently connected/identified by the UT as available for data traffic.
Conn Busy
The data connection is currently busy.
Conn Failed
The attempt to open the data connection has failed.
Conn Opened
The data connection was opened successfully.
When deactivating the data connection from the menu, these messages are possible:
Closing...
The mobile terminal is currently closing the data connection.
Conn Busy
The data connection is currently busy.
Conn Error
An error occurred while closing the data connection.
Conn Closed
The data connection was closed successfully.
If in pointing mode, these messages are possible on the LCD:
Insert SIM
There was no SIM detected; pointing can still continue, but once complete, "No SIM"
will appear permanently.
Wrong SIM
The SIM detected is not the SIM that was locked to the mobile terminal
At any time during operation, this message is possible on the LCD:
Battery Low!
The battery is extremely low. Plug in the DC cord to avoid automatic power off when
the battery level becomes critical. This message persists until the condition has been
corrected or a button is pressed.
Table 5 shows possible error and status messages with explanations and suggested
actions. Most of these messages will self-clear after 15 seconds, or can be cleared
immediately by pressing any button on the front panel.
Table 5: Quick-text status message descriptions
Chapter 3 • Using the LCD and keypad
H61798 Revision E
25
Advertisement
Table of Contents
