Tripp Lite NetDirector B060-032 Owner's Manual page 24

OSD Operation
CLEAR THE NAME LIST
ACTIVATE BEEPER
SET QUICK VIEW PORTS
SET ACCESSIBLE PORTS
SET ACCESS TIMEOUT
SET KEYBOARD LANGUAGE
SET OPERATING PLATFORM
BUS AUTHORIZATION
FIRMWARE UPGRADE
(continued)
This is similar to Restore Default Values. The difference is that it
also clears the Names settings along with undoing all changes and
returning the setup to the original factory default setting.
Choices are Y (for Yes), or N (for No). When activated, the beeper
sounds whenever a Port is changed; when activating the Auto Scan
function (see F7 SCAN, p. 25); or an invalid entry is made on an
OSD menu. The default is Y (activated).
This function lets the Administrator select which Ports to include
as Quick View ports.
• To select/deselect a port as a Quick View Port, Double Click the
port you want, or use the Navigation Keys to move the highlight
bar to it, then press [Enter].
• When a port has been selected as a Quick View Port, an arrowhead
displays in the QV column of the LIST on the Main Screen to
indicate so. When a port is deselected, the arrowhead disappears.
• If one of the Quick View options is chosen for the LIST view
(see F2 LIST, p. 21), only a Port that has been selected here will
display on the List.
• If one of the Quick View options is chosen for Auto Scanning
(see SCAN/SKIP MODE, p. 22), only a Port that has been
selected here will be Auto Scanned. The default is for no ports to
be selected.
This function lets the Administrator define Operator access to the
computers on the installation on a Port-by-Port basis.
For each Operator, select the target Port; then press the [Spacebar]
to cycle through the choices: F (Full access), V (View Only), or
blank (No access). Repeat until all access rights have been set, then
press [Enter]. The default is F for all users on all Ports.
Note: A blank setting means that no access rights are granted. The
Port will not show up on the User's LIST on the Main Screen.
If there is no input from the console accessing a particular port for
the amount of time set with this function, the port is released,
allowing it to be accessed by the other consoles.
To set the timeout value, key in a number from 0 - 255 seconds,
then press [Enter].
If the number is 0 [zero], this function is disabled. The default is
5 seconds.
This function allows the Administrator to define the keyboard
language layout for each port. To assign a keyboard language,
select the target port; then press the [Spacebar] to cycle through
the choices: US English; Japanese; or French.
The default is US English.
This allows the Administrator to define the operating platform for
the system connected to each port. To assign an operating platform,
select the port; then press the [Spacebar] to cycle through the
choices: Windows (PC compatible); Mac; and Sun.
The default is Windows (PC compatible).
This function allows the Super Administrator to authorize Operator
access to Stations on the installation other than the ones connected
to the Station the Operator is logged in on.
For each Operator, press the [Spacebar] to cycle through the
choices: F (Full access), V (View Only), or blank (No access).
Repeat until all access rights have been set, then press [Enter].
The default is blank - No Operators have access rights to
other Stations (and the computers connected to them).
In order to upgrade the B060-032's firmware, you must invoke
Firmware Upgrade Mode with this setting. Only the Super
Administrator on the Master Station can use this function.
24