Mounting The Control Head; Installing The Battery - Humminbird Ice Helix Installation Manual

ICE HELIX® PORTABLE CONVERSION KIT Installation Guide
4. Place the cover onto the tray. Hold the tray together and turn it over.
If the cable tray arms fall out, see the illustration Assembling the Cable Tray to put them back
in place.
5. Install the screws in the holes on the bottom of the tray. Hand-tighten only. See the illustration
Removing the Screws to replace the screws.
6. Turn over the cable tray so the Humminbird logo is facing up. Confirm the cables hang straight,
and untwist them if necessary.
4

| Mounting the Control Head

1. Place 1 washer onto each gimbal knob.
2. Install the gimbal knobs (with washers) into each side of the control head. Tighten the knobs
just enough so you can slide the control head into the gimbal bracket arms.
3. Slide the control head (with gimbal knobs installed) into the gimbal bracket arms.
4. Line up the slots on the cable tray with the matching ports on the back of the control head.
Line up the cable tray pins with the holes on the control head (see the illustration Locating
the Cable Tray Slots).
With the Humminbird logo facing up, plug the cable tray into the back of the control head. The
cable tray clasps should click into place.
5. Pull carefully on the cable tray to confirm the installation is secure. Make sure both clasps
clicked into place.
6. Adjust the control head viewing angle, and tighten the gimbal knobs so the control head is
secured on the gimbal bracket. Hand-tighten only!
5

| Installing the Battery

Before proceeding with this procedure, confirm the battery is fully charged (see Charging the
Battery).
Locating the Cable Tray Slots
COM
(communications) power
transducer
pin Ethernet temp/
Assembling the Control Head and Gimbal Bracket
pin
speed
5
532686-1_A
Turning over the Cable Tray
cover
Inserting the Cable Connectors
into the Cable Tray
power connector
notch facing up
power
transducer
cable
groove
Assembling the Cable Tray
cover
keep arms
in place