Troubleshooting When Using 3D Mode - LG D2000N Owner's Manual

20
TROUBLESHOOTING
TROUBLESHOOTING WHEN USING 3D MODE
Images displayed are not in 3D.
If you view 3D images outside the
optimal viewing angle or distance,
If you have not set the resolution,
If left/right images are reversed
If ambient brightness is low
If the camera display for facial
recognition is not shown
Miscellaneous
I cannot see 3D but only 2D images.
y This monitor works both in 2D and 3D mode. You can view a video in 3D if it is made in 3D. If you try to view 2D
images in 3D, they might not be displayed properly or you may experience poor picture quality.V
If the 'TriDef 3D' couldn't work properly
y TriDef 3D needs the following minimum system requirements to function properly.
y Minimum System Requirements for TriDef 3D
» Intel® Core 2 Duo or AMD Athlon™ 64 X2 Dual-Core CPU or higher
» 1 GB RAM
» NVIDIA® GeForce® GTS 450 or AMD Radeon™ HD5750 or higher (latest graphics card driver required)
» 500 MB of free disk space
» Windows® XP (with latest service pack; 32-bit only), Windows® Vista (32-bit only) or Windows® 7 (32-bit or 64-bit)
» DirectX 9.0c compatible sound card
» Internet connection
» DVD-ROM Drive
» Network card
» DirectX 9.0c
y Recommended System Requirements for TriDef 3D
» Intel® Core i5 or AMD Phenom™ Ⅱ X 4 CPU or higher
» 2 GB RAM
» NVIDIA® GeForce® GTS 260 or AMD Radeon™ HD5770 or higher (latest graphic card driver required)
» Windows® XP (with latest service pack; 32-bit only), Windows® Vista (32-bit only) or Windows® 7 (32-bit or 64-bit)
» DirectX 9.0c compatible sound card
» Internet connection
» DVD-ROM Drive
» Network card
» DirectX 9.0c
NOTE
To run a 3D game properly, you need the minimum system requirements for the game.
y y
y The optimal viewing angle of the monitor is 12° in vertical direction while 80°
in horizontal direction; the optimal viewing distance is between 50 cm to 90 cm
from the monitor.
y When you view 3D images outside the optimal viewing angle or viewing
distance, the images may look overlapped or not be displayed properly in 3D.
y Please set the resolution of the monitor to the maximum (1920 x 1080 @
60 Hz) in the display settings. The 3D software may not work properly if the
resolution is not set to the maximum.
y Sometimes, left/right images from the 3D content input are reversed.Change
the left/right image sequence in the player or viewer settings of the 3D
software.(Refer to the Installation Manual for 3D Viewing.)
y A user's face must be detected through the camera attached to the front of the
monitor front in order to enable 3D.
y Increase the ambient brightness for the camera display to detect the face.
y Check the USB cable connection. If it is properly connected, change the USB
port and reconnect.
y Carry out the following if you see the messages below in the PC:
"This Device Can Perform Faster" (Windows 7)
"HI-SPEED USB Device Attached To Non-HI-SPEED Hub" (Windows XP)
» Troubleshooting
1. Change the USB port before plugging in.
2. Use a rear USB port, rather than a front USB port, for the desktop
computer.
y If you see doubled images or shaky images, re-run the TriDef 3D calibration
program to adjust 3D images.(Refer to the Installation Manual for 3D Viewing.)