Under normal conditions, the original batteries in your UPS will last many years. See Safety section
before replacing batteries. The batteries are designed for hot-swap replacement (i.e. leaving the UPS
in ON mode), but some users may wish to put the UPS in the OFF mode before proceeding.
1U UPS Models
Specifications
Model
Series #
Input
Nominal Voltage/Frequency:
Suggested Circuit:
Output
Capacity (VA/Watts)
On Line Nominal Voltage/Waveform:
On Battery Nominal Voltage/Waveform: 230VAC/PWM sine wave
Battery Runtime (Half Load/Full Load)
Battery Recharge Time (to 90% charge)
Typical Transfer Time
Approvals:
* Battery runtime for these models can be increased with the addition of optional external battery packs. Adding external battery packs will also increase recharge time.
ALL MODELS: Voltage-Regulated Output Voltage Range (230V +/- 9%); On Battery Output Voltage Range (230V +/- 5%); AC Surge Suppression (exceeds IEEE 587
Cat. A & B standards); AC Noise Attenuation (>40 dB); AC Protection Modes (H to N).
The policy of Tripp Lite is one of continuous improvement. Specifications are subject to change without notice.