Moving The Chassis To The Final Location - Cisco NCS 4000 Series Manual

Moving the Cisco NCS 4016 Chassis
If the route to the installation site has any ramps, use a moving device other than a scissor lift to move the
Caution
chassis over the ramps, and then transfer the chassis onto a suitable lifting device such as a scissor lift for
installation. Leave the filler cards in place in empty card slots while you move or install the chassis in the
rack. The filler cards provide support to keep the chassis square during movement and installation.

Moving the Chassis to the Final Location

This section describes how to move the as-shipped Cisco NCS 4016 chassis.
The chassis is shipped with filler cards per the configuration ordered. Leave these in place to maintain
Caution
chassis stiffness and integrity during moving.
To move the Cisco NCS 4016 chassis to its installation location, follow these steps:
SUMMARY STEPS
1. Make sure you have a suitable lifting device to move the Cisco NCS 4016 chassis.
2. Move the chassis to its installation location.
DETAILED STEPS
Step 1 Make sure you have a suitable lifting device to move the Cisco NCS 4016 chassis.
Step 2
Move the chassis to its installation location.
What to Do Next
What to Do Next
After moving the chassis to the room or area where you will install it, begin the procedure to mount the chassis
into the rack.
Cisco Network Convergence System 4000 Series Unpacking, Moving and Securing Guide
Moving the Chassis to the Final Location
21