Epson EB-1485Fi Installation Manual page 112

Installing the Touch Unit

The position of your finger may not be detected
even if you touch the projected image.

Even if you do not touch the projected image,
touch operations may be incorrectly detected and
unintended operations may be performed.
c
Check the following before adjusting the angle of the laser.

The Interactive Pen calibration has been performed. (

The Edge Blending setting is turned off
When Edge Blending is set to On, angle adjustment for the laser may fail. Temporarily set Edge
Blending to Off, re-calibrate the pen, and then adjust the angle of the laser.
a
When you install two projectors side-by-side, set HDMI Out Setting to Process Out from
the Multi-Projection menu
Follow the on-screen instructions to restart the projector.
b
Select Touch Unit from the Installation menu
When the laser is not parallel to the screen


The position of your finger detected by the pro‐
jector and your actual finger position may not
align, and an unintended operation may be per‐
formed.
The projector enters a state in which a touch is
still being detected, and a click operation is not
recognized.
p.86)
s
111