Optical Transceivers And Cabling Installation - Dell MXG610s Setup Manual

Figure 9. Monitoring settings
7 Click and expand the Advanced Settings option. Select the needed check boxes.
Figure 10. Advanced settings
8 Click Apply.
You have configured the IP address and other settings for the switch module.

Optical transceivers and cabling installation

NOTE: When cabling SFP+ optical transceivers, start from port 0, then port 17, and
then the other ports.
To insert the optical transceivers and the cable connections:
1 Insert the optical transceiver in an external port on the switch module until it is firmly
seated and the latching mechanism clicks.
Transceivers are keyed to ensure correct orientation. If a transceiver does not install
easily, ensure that it is correctly oriented.
2 Insert the fiber optic cable in the SFP+ or QSFP optical transceiver until the latching
mechanism clicks.
Cable connectors are keyed to ensure correct orientation. If a cable connector does not
install easily, ensure that it is correctly oriented.
12 MXG610s Setup Guide