Connecting To Your Network - D-Link DAP-2230 Quick Installation Manual

Connecting to Your Network

You can connect the DAP-2230 to a PoE
switch, or you can use a PoE injector to power
the Access Point.
Connecting to a PoE Switch
Connect the Ethernet cable that is connected
to the DAP-2230 to your PoE switch.
AP
LAN (PoE)
A
PoE Switch
Connecting to a PoE Injector
A. Connect the Ethernet cable that is
connected to the DAP-2230 to the P+DATA
OUT port on the PoE injector.
B. Connect an Ethernet cable to the DATA IN
port on the PoE Injector. Connect the other
end of the Ethernet cable to your network
switch or router.
C. Attach the power adapter to the connector
labeled POWER IN on the PoE Injector,
and plug it into an electrical outlet.
AP
LAN (PoE)
A
P+DATA OUT
POWER IN
C
Router or Switch Computer
TECHNICAL SUPPORT
Computer
PoE Injector
DATA IN
B
If you are configuring the DAP-2230 locally,
connect a PC to same network that the
DAP-2230 is connected to.
A. Assign a static IP address to your PC
that is in the same network segment as
the DAP-2230. As the default IP address
of this unit is 192.168.0.50, you may
choose any address from 192.168.0.1 to
192.168.0.254, except 192.168.0.50.
B. Open a web browser and go to
http://192.168.0.50. Enter admin as your
username and leave the password blank to
the DAP-2230 through the web UI.
dlink.com/support
D-Link DAP-2230 Quick Install Guide
3