National Vendors 112-2424 Instructions For Installing

INSTRUCTIONS F O R INSTALLING A HEAVY LOCK PLATE KIT IN A NATIONAL VENDORS@,
CROWN LINE@SERIES
CHECK THE PARTS RECEIVED IN THE KIT WITH THE PARTS LIST
IN THESE INSTRUCTIONS. I F ANY PARTS ARE MISSING, CONTACT
NATIONAL VENDORS' PARTS DEPARTMENT IMMEDIATELY.
These instructions cover the procedure for installing a
Heavy Lock Plate Kit in a Crown Line Manual Candy
Merchandiser.
Read these instructions carefully and thoroughly
before installing the Kit. Retain these instructions for part
number and installation information.
Kit, Heavy Lock Plate, part number 112-2424,
contains the following parts:
Part Number Description
11 2-2421
Heavy Lock Plate Assembly
114-1046
Lock Keeper Screw
11 2-2425
Installation Instructions
* * *
TO INSTALL THE KIT
A. PARTS REMOVAL
1. Open the Cabinet Door and lower the Door
Holder Leg.
Be sure the Door Holder Leg is rotated into the Down
Position before proceeding to the next steps. Shifting
the weight of the Delivery Mechanism to the front
could cause the Cabinet to tip over,causing personal
injury and equipment damage.
Rotate the Delivery Mechanism out of the Cabinet
2.
as follows:
a. Remove the Money Box
b. Remove the two Thumb Screws which attach
the top rear of the Delivery Mechanism to
two brackets located on the upper inside rear
wall of the Cabinet.
c. Disengage the Stops located at the front
flanges of both the Left and Right
bottom
Sidewall and slide the Delivery Mechanism
straight out of the Cabinet, until it strikes the
spring of the Pivot Stop on the left side.
C o p y r i g h t
cc,
CANDY CUPBOARD , CROWN ELITE AND GOLDEN CABARET
MANUAL CANDY MERCHANDISER
Quantity
1
2
1
Printed in
b y N a t i o n a l Vendors
d. Pivot the right side of the Delivery Mechanism
out of the Cabinet.
3. Remove two attaching Screws and the standard
Lock Plate Assembly from the Mounting Bracket
on the right wall of the Cabinet.
B. THE
INSTALLATION O F
1. Attach the Heavy Lock Plate Assembly, part
number 112-2421, to the Mounting Bracket on
the right cabinet wall with the two Lock Keeper
Screws, part number 114-1046. Both parts are
included in the Kit. See Figure.
2. Return the Delivery Mechanism to the In-Cabinet
position as follows.
a. Pivot the right side of the Delivery Mechanism
toward the rear of the Cabinet until the front
o f the Delivery Mechanism is parallel to the
Base and the Shelf of the Cabinet.
b. Push the Delivery Mechanism straight into
the Cabinet, carefully maintaining alignment
in both the Left and Right Mounting Bracket
Assemblies on the floor of the Cabinet Shelf.
RIGHT CABINET WALL
RIGHT CABINET WALL
LOCK KEEPER SCREW LOCK KEEPER SCREW
1 14-1 046 1 14-1 046
HEAVY LOCK PLATE ASSEMBLY
112-2421
FIGURE 1
U.S.A.
A Division of UMC Industries,
KIT
MOUNTING
112-2425