Carrying And Installing - Saturn ST-CF1901 Instruction Manual

Safety information
Warning and Attention
Remove the door seal to avoid asphyxia if
children inside the cabinet, when the
appliance is abandoned.
Plug out and take all the stored goods out
before moving to avoid the appliance
damaged or the users hurt.
Remove the flammable bottom polyfoams
before using to avoid fire.
Connect to potable water supply only.
Do not touch the surface to avoid any scald
during working or right after plugging out.
At this moment, the surface is at a high
temperature.
Do not let children take goods out by
themselves to avoid any hazard.
The refrigerant is flammable.
Do ask Service Dept to repair if the cooling
system has some problem.
Do not disassemble, repair or modify the
appliance by yourselves to avoid any
refrigerant leakage.
The refrigerant may ignite or cause eye injuries.
WARNING: Keep ventilation openings, in the
appliance enclosure or in the
built-in structure ,clear of obstruction.
WARNING: Do not use mechanical devices or
other means to accelerate the
defrosting process ,other than those
recommended by the manufacture.
WARNING: Do not use electrical appliances
inside the food storage compartments
of the appliance, unless they are of
type recommended by the manufacturer.
5

Carrying and installing

Carry the appliance carefully and avoid
collisions and big shakes .
The incline angle should be less than 45
during carrying to avoid damages of the
cooling system.
The ground should be flat, sturdy and
horizontal for a stable installing.
It is not only for safety, but also for a stable
working of the compressor without big
shocks and noises.
Install the appliance in a dry place.
The appliance will get rusted and have a
poor insulation if in a place with humidity
or water for a long time.
Do not install the appliance in the outside
place where rain can reach.
Check all the positions for the package.
Pack the appliance according to the orignial
one before carrying.
Do not place the appliance under sunshine or
near heating sources.
It will increase the power consumption and
decrease plastic parts or surface coatings life.
The appliance should have some distance
from circumferences for good ventilation,
heat radiation and power consumption
decreasing.
6