Table of Contents
Advertisement
OPTIONAL
To remove
the distance
guide
lines:
1. Turn
the
system OFF before proceeding
2. Cut the loop
located
at the connection
points
(camera end).
3. Insulate
the
wire,
using
tape or crimp connectors on
both
ends.
4. Rejoining the wire will bring the guide lines
back
after a power cycle
if wanted.
TROUBLESHOOTING GUIDE
The following checklist might help to solve the
problems
when
using
this
unit.
Please double check
to
insure connection and procedure of operation is done
properly before using checklist.
PROBLEM
NO IMAGE
IMAGE BLURRING
IMAGE SHAKING
IMAGE SLANTED
NOTE:
CAUSE/SOLUTION
Check that power cable is securely connected.
Check to insure there is a good connection between
video-in and monitor.
Check that REVERSE GEAR
is
engaged.
Check
to
insure correct
monitor
setup.
Check for water/water stain or dust on camera lens.
Clean camera lens
Check to insure camera is mounted and secured tightly.
Adjust camera mounting bracket
If problems persist
-
consult nearest service
dealer.
DO NOT attempt to
disassemble or modify unit.
Hide quick links:
Advertisement
Table of Contents
