Graco A Series Repair And Parts Manual page 15

Removal
1. Remove Pinion Assembly/Rotor/Field/Pinion/
Clutch, Clamp and Clutch Housing, as in-
structed on pages 12, 13, and 14.
2. Fig. 15. Disconnect all necessary wiring.
3. Fig. 16. Remove two locknuts (18) and
screws (17) from base of engine.
4. Lift engine carefully and place on work bench.
NOTE: All service to the engine must be performed by
an authorized HONDA dealer.
SPRAYER WIRING DIAGRAM
6 Wires
Red, Yellow, Green,
Blue, White, Black
Transducer
Fig. 15
70
71
Fig. 16
Engine
Air valve
8710A
Installation
1. Lift engine carefully and place on cart.
2. Fig. 16. Install two screws (17) in base of engine
and secure with locknuts (18). Torque to 200 in-lb
(22.6 NSm).
3. Fig. 15. Connect all necessary wiring.
4. Install Pinion Assembly/Rotor/Field/Pinion/
Clutch, Clamp and Clutch Housing, as
instructed on pages 12 and 13 and 14.
Flow control
2X Red
2X Black
Flow sensor regulator
TI3110A
309662 15