Bissell ProBag DayClean BG101H User Manual page 5

A
ssembly
1. Locate hardware pack for handle
assembly. Enclosed are two nut and bolts
for the handle, as well as upper (larger)
and lower (smaller) plastic cord hooks.
An extra drive belt is also included.
2. Connect lower handle to the base of the
unit. The thinner end should point upwards,
toward the top of vacuum. Connect upper
handle to lower handle by sliding into each
other. Upper handle should curve towards
the back of the unit. Insert nuts and bolts
and tighten.
3. Thread nut and bolt through hole in upper
and lower handle. Screw together nut and
bolt by hand, then tighten with screwdriver.
4. Take lower cord hook with vacuum facing
frontwards and snap into slot on lower
handle with hook facing down.
5. Take upper cord hook and place cord with
spring retainer into slot and snap in.
6. Wrap cord around cord clips.
7. To attach the bag to the vacuum, find hook
on the bottom of the bag and hook it to
the back of the vacuum base. (See image)
Align latch with the back of the vacuum
and bring the collar forward. Turn latch so
that bag locks onto rivet.
8. Attach spring from top of cloth bag to the
bag clip on upper cord hook.
ATTENTION:
Some Berber carpets have a
tendency to fuzz with wear.
Repeated strokes in the same
area with an ordinary vacuum or
deep cleaner may aggravate this
condition.
1.
6
4.
7a. 7b.
5