Summary of Contents for Supermicro BPN-ADP-2M2-1UB
Page 1
5. Remove any DIMMs obstructing access to the BPN-ADP-2M2-1UB 7. Remove the two screws from the left hand side of the chassis that secure the BPN-ADP-2M2-1UB to the chassis 8. Pull the card out of the socket by both notched edges (front and back) of the card. Be careful not to exert any force on any M.2...
Page 2
3. Remove the chassis from the rack 4. Take off cover and remove any DIMMs obstructing access to the BPN-ADP-2M2-1UB’s socket 7. Install the standoffs in the appropriate holes that correspond with the form factor of the M.2 SSD to be installed (42mm, 60mm or...
Page 3
8. Insert one or two M.2 SSDs into the slots on the expansion card as illustrated below.
Page 4
9. Secure each M.2 by firmly inserting the standoff plug per the illustration below.
Page 5
10. With the screws provided, secure the BPN-ADP-2M2-1UB to the chassis...
Page 6
11. Replace any DIMMs that may have been removed 12. Replace cover and re-rack. 13. Plug the power cords into the rear of the power supply and power up the system...