The ROCKWOOD PNEUMATIC MINI BELT SANDER is compact and powerful with an adjustable angle sanding arm for ease in grinding and sanding difficult to reach areas. It features a sealed ball bear- ing drive assembly for smooth, low vibration operation and long life. The precision diecast housing provides a solid foundation and offers ergonomic, one handed operation with a convenient handle mounted paddle trigger.
SAFETY INFORMATION The following explanations are displayed in this manual, on the labeling, and on all other information provided with this product: DANGER indicates a hazardous situation which, if not avoided, will result in death or serious injury. WARNING indicates a hazardous situation which, if not avoided, could result in death or serious injury. CAUTION used with the safety alert symbol, indicates a hazardous situation which, if not avoided, could result in minor or moderate injury.
BURSTING HAZARD! • Do not exceed 90 psi (6.2 bar) of tool inlet pressure. Permanent tool damage and/or bursting could occur and cause personal injury. INJURY HAZARD! • This tool has high-speed, abrasive surfaces which can quickly cause injury. Keep fingers and hands away from moving parts when operating. Wear thick, well-fitting work gloves and keep loose clothing, sleeves, cords, jewelry and hair away from moving parts.
OPERATION INJURY HAZARD! Disconnect air supply from the tool to prevent accidental starting and potential injury while installing or removing Abrasive Belts. • Depress Throttle Paddle inward with fingers to operate tool. • Keep the broad work surface of the Abrasive Belt parallel to the work surface whenever possible to minimize uneven wear and maximize usable life.
ADJUSTING SANDING ARM ANGLE INJURY HAZARD! Disconnect air supply from the tool to prevent accidental starting and potential injury while installing or removing Abrasive Belts. • Disconnect air supply from the tool to prevent FIG. 4 accidental starting and potential injury while adjusting the Abrasive Belt Arm Angle.
TROUBLESHOOTING PROBLEM CAUSE CORRECTION Insufficient CFM at tool inlet Tool Doesn’t (4 CFM @ 90 Verify sufficient air supply to tool. Respond to PSI minimum Paddle for best results) Depression Tool contaminat- Check for moisture in air line and tool air inlet. ed by moisture Insufficient CFM at tool inlet...
ADDITIONAL ITEMS #30661 5 Pack of 60 Grit, 3/8” x 13” Abrasive Belts #30662 5 Pack of 80 Grit, 3/8” x 13” Abrasive Belts #70491 Eastwood Industrial Air Hose, 3/8” x 25’ #70492 Eastwood Industrial Air Hose, 3/8” x 50’ If you have any questions about the use of this product, please contact The Eastwood Technical Assistance Service Department: 800.343.9353 >>...