4.1.6.
Attaching the Front PCB
1. Connect the Cable to the Front PCB Connecter (CN919) and fix to the Base Plate Ass'y with 2 Screws <N2>. No.1 to No.2.
2. Fix the Cable Cover with 3 Screws <N2>. No.3 to No.5.
■ Attaching the Cable Cover and Screw Cover Sheet.
S1:
S2:
S4:
S5:
S1:Insulation S2:Pinching Cables
CAUTION
S3:Sharp Edge S4:Check Parts NO. S5:Others
*Notice
1. Attach Front PCB to Base Plate Ass'y and
tighten with Screws<N2>.
Use the special jig.
Tightening order of Screws<N2>: a - b
2. Connect Cable<E2> to Front PCB.
After connection, remove the Release Paper
of the Cable Tape attached to Base Plate Ass'y
and attach Cable<E2> to Base Plate Ass'y.
See fig. 2.
3. Attach Cable Cover to Base Plate Ass'y and
tighten with Screws<N2>.
Use the special jig.
At the same time, tighten the Key angle with
Screws<N2> through Base Plate Ass'y.
Tightening order of Screws<N2>: c - d - e - f
4. Remove the Release Paper of the back side
of Screw Cover Sheet L and Screw Cover Sheet R
and insert the tab of tip into the long hole of Base Plate.
S3:
Cable Cover
Screw<N2>
S2
Front PCB
S2
<N2> :No.3
<N2>
:No.5
<N2>
:No.4
<N2> :No.1
<N2> :No.2
Connector(CN919)
Base Plate Ass'y
Screw<N2>
c
e
b
a
f f
Screw
Cover Sheet L
4-11
Cable Cover
Front PCB
Base
Plate Ass'y
d
Cable<E2>
Screw Cover Sheet R
Base Plate Ass'y
Screw<N2>
Cable
<E2>
fig.2