Related Manuals for NatComm RI-SIP
Summary of Contents for NatComm RI-SIP
- Page 1 RI-SIP USER GUIDE For Technical Assistance Please Ph: 07 5596 5128 (9AM to 5PM QLD Time) or Email : info@natcomm.com.au...
- Page 2 DESCRIPTION RI-SIP is a SIP based Ring Indicator device which can operate with Any IP based PBX system, including Cloud PBX systems. RI-SIP has 2 Internal Relays for control of external equipment Relay 1 Closes and Opens its NTERNAL DRY RELAY CONTACTS (RJ45 pins 2 &...
-
Page 3: Connection Overview
CONNECTION OVERVIEW PBX CONNECTION RI-SIP is designed to connect as a SIP Client of an IP based PBX. It has an RJ45 Socket for Network Connection. It is supplied with a CAT5 connection cable. will connect to your PBX Network via DHCP and you can then... -
Page 4: Installation Diagram
8 Pin to 4 Pin connection cable is supplied. Tone Alert Accessory is supplied with a short cable which has an 8 Pin Plug for connection to RI-SIP and a 4 Pin Plug for connection to Tone Alert. Tone Alert... - Page 5 STROBE ALERT CONNECTION Strobe Alert Accessory is supplied with a short cable which has an 8 Pin Plug for connection to RI-SIP and a 4 Pin Plug for connection to Strobe Alert. Strobe Alert will FLASH all 8 High Intensity Red LED as soon as Incoming Ring is detected.
- Page 6 To Connection Box Accessory A Screw Terminal Connection Box may be supplied with RI-SIP Relay 1 Connection To Connect to Relay 1 of RI-SIP, use the screw terminals that connect to the ORANGE and BROWN wires in the Connection Box. Relay 2 Connection To Connect to Relay 2 of RI-SIP, use the screw terminals that connect to the BLUE and WHITE wires in the Connection Box.
- Page 7 SIP INSTALLATION A Windows based program (called Natcomm SIP Controller) is supplied for your RI-SIP unit. This program is designed for use on PC running Windows 7 or later (on your same network). Install the program by double clicking the supplied Program file.
- Page 8 Go into the Phone 1 Menu Enter Phone 1 Now Enter Your : Extension Number User Name Password Scroll Down to the Bottom of the Page You MUST Click Save When complete You MUST Click Reload See Arrow Above Page 8 Natcomm...
- Page 9 Enter NETWORK SERVER IP ADDRESS Go into the Menu A & B Enter the SIP Menu Enter Here Your SIP Server IP Address Make sure the Send Registration Request with Expire Time is ticked. It should only be unticked for a direct peer to peer IP connection.
- Page 10 Changing from DHCP to Static IP Go into the Settings Menu Enter Settings Menu Deselect DHCP Here Enter Static IP Settings Here or Here Scroll Down to the Bottom of the Page You MUST Then Click Save and Reload Page 10 Natcomm...
- Page 11 Now Reload to Effect Your Changes Go into the Reload Menu Leave the Default Setting Unchanged ‘Reset and execute Main Application’ Now Click Reset There will be a short delay while the ATA resets itself save Downloading the ATA User Guide Go into the Users Guide Menu...
-
Page 12: Specifications
Damage caused to this device or attached equipment by connecting a Power Adaptor other than as supplied, is not covered under this warranty THE CASE IS SEALED AT THE FACTORY. OPENING THE CASE WILL VOID THE WARRANTY. Page 12 Natcomm...