Advertisement
Quick Links
Advertisement
Summary of Contents for CONCORD Elevation
- Page 1 The Responsible Solution Elevations Assembly Instructions...
-
Page 2: Control Box
ITEM DESCRIPTION WORKSURFACE CONTROL BOX HANDSET, CONTROL BOX AND P-CLIP FASTENERS CONTROL BOX POWER CORD LEG ASSEMBLY MOUNTING FASTENERS LEG ASSEMBLY HANDSET CROSS BRACE FASTENERS (OPTIONAL) CROSS BRACE BOLTS (OPTIONAL) - Page 3 STEP 1: ASSEMBLE FRAME Set worksurface upside down on a flat stable surface. Locate 2 leg assemblies and cross braces (if included) on work surface. If your table has only one cross brace, position the cross brace to the back of the worksurface. Insert cross brace fasteners hand tight (3 locations on each cross brace end, see FIGURE "A").
- Page 4 STEP 3: ASSEMBLE ELECTRONICS Locate the handset and control box on the work surface as shown in Figure "E", Figure "F" and Figure "G".Once the control box and handset are located in their approximate position, insert the corresponding mounting fasteners.
- Page 5 STEP 4: ELECTRICAL CONNECTIONS DO NOT PLUG IN POWER CORD INTO THE ELECTRICAL OUTLET UNTIL LEG ASSEMBLIES AND HAND- SET ARE CONNECTED TO CONTROL BOX. Connect handset cord and leg assembly cords, to the control box. See FIGURE "I".Use wire P-clip fasteners to secure wires to tabletop.
- Page 6 STEP 6: FIRST TIME INITIALIZING THE LEGS.Depress and hold the down button. The table will move slightly down and then slightly back up. Release the down button. The legs are now initialized and ready for use. STEP 7: CHANGING THE DISPLAY HEIGHT. If the display height does not match the actual height of the table top, follow these steps. Press the memory key.
- Page 8 The Responsible Solution COMMITTED TO: the environment responsible manufacturing minimal waste www.concordproducts.com 1 800 220 5043 ® Trademarks of Concord Products Company, Inc. INSTAL-ELEVATION-0121...