Flexible Arm Installation
This monitor is designed for use with a flexible arm. Contact NEC for more information.
Follow the instructions provided by the manufacturer of the display mount. Remove the monitor stand before mounting.
CAUTION::
To meet the safety requirements, the monitor must be mounted to an arm that supports the weight of the
monitor. See the Specifications -
Remove the Monitor Stand for Mounting
NOTE::
- Handle with care when removing the monitor stand.
- If the cable cover is installed, remove it before removing the monitor stand.
- You do not need to separate the base stand from the monitor stand.
The monitor stand can be removed with the base stand attached.
1
Mount the Flexible Arm
Using four screws that meet the specifications listed below, attach the arm to the monitor.
12 mm
M4
4 x 12 mm with lock
washer and flat washer
100 mm
CAUTION: •
The monitor should only be used with an approved arm (e.g. TUEV NS mark).
•
Tighten all screws (recommended fasten torqueN 98 - 137 N•cm).
•
Attaching the flexible arm should be done by two or more people if the monitor cannot be placed face down
on a flat surface for installation.
•
The monitor must be used in the landscape position. hen mounting on a flexible arm, please set the
monitor in the landscape position with the LED indicator on the bottom bezel.
"AS173M" on page 21 and "AS194Mi" on page 22
2
Non-abrasive surface
Lock washer and
flat washer
100 mm
English−27
for details.
3
Screw (M4)
Thickness of bracket
and washer
6 - 8 mm