Repair; Replace The Datatrak Battery - Graco EcoQuip 2 EQs Instructions Manual

Repair

Repair

Replace the DataTrak Battery

To reduce the risk of fire and explosion, the battery
must be replaced in a non-hazardous location.
Use only an approved replacement battery (see
table). Use of an unapproved battery will void
Graco's warranty.
Replace Battery
1. Unscrew cable from the back of the reed switch
assembly.
2. Remove the cable from the two cable clips.
36
3. Remove the DataTrak module from the bracket.
Take the module and attached cable to a
non-hazardous location.
4. Remove the two screws on the back of the module
to access the battery.
5. Disconnect the used battery and replace it with an
approved battery.
Approved Batteries
®
Energizer brand alkaline #522
®
Varta brand alkaline #4922
®
UltraLife brand lithium #U9VL
®
Duracell brand alkaline #MN1604
3A7467C