On-Board Computer - Renault Trafic Manual

ON-BOARD COMPUTER

1
2
Display 1
General reset and trip mileage
recorder reset button 2
To reset the trip mileage recorder,
the display must show the Trip
mileometer function.
1.56
Display selection key 3
Press button 3 repeatedly to scroll
through the following information:
a) total mileage recorder;
b) trip mileage;
3
c) fuel used;
d) average consumption,
e) current consumption,
f) estimated range,
g) distance covered,
h) average speed,
Refer to the table on the following
page for display examples.
Interpreting
displayed after a reset:
The values showing average fuel
consumption, range and average
speed will become more stable and
reliable the further you travel since
the last time the reset key was
pressed.
For the first few miles after pressing
the reset key you will notice:
• that the range increases as you
certain values
• You may also notice that the
Note: resetting is automatic when
the maximum capacity of any of the
memories is exceeded.
travel. This is normal, average
fuel consumption may decrease
when:
- the vehicle stops accelerating,
- the engine reaches its operating
temperature (engine cold when
reset button pressed),
- when driving from a built-up
area onto the open road.
Therefore, if the average fuel
consumption decreases,
range will increase.
average fuel consumption
increases when the vehicle is
stationary and the engine idling.
This is normal since the computer
takes account of fuel used during
idling.
the