Inserting Batteries - Toshiba MW20FN3/R Owner's Manual

Inserting Batteries

1
Slide the battery compartment
cover in the direction of the
arrow.
Battery precautions:
The precautions below should be followed when using batteries in this device:
1. Use only the size and type of batteries specified.
2. Be sure to follow the correct polarity when installing the batteries as indicated in the battery compartment. Re-
versed batteries may cause damage to the device. To avoid a potential short circuit, insert the "–" end first.
3. Do not mix different types of batteries together (e.g. Alkaline and Carbon-zinc) or old batteries with fresh ones.
4. If the device is not to be used for a long period of time, remove the batteries to prevent damage or injury from
possible battery leakage.
5. Do not try to recharge batteries not intended to be recharged; they can overheat and rupture. (Follow battery
manufacturer's directions.)
Remote control basics
• Press POWER to turn the unit on or off.
• Select your desired operating mode (TV/VCR or DVD) using TV/VCR or DVD.
• Tap CH or CH to move through the channels one channel at a time.
• The Direction buttons ( / /
• You can directly access specific channels using Direct channel selection buttons.
Operation:
• Aim the remote control at the remote sensor and press control buttons to
operate.
• Operate the remote control within 30 angle on either side of the remote
sensor, up to a distance of Approx. 7 meters.
2 Install two "AAA" batteries
(supplied), paying attention to the
polarity diagram in the battery
compartment.
/ ) are also used to navigate on-screen menu system.
3 Replace the compartment
cover.
Approx. 7 meters
13