U-Line H-6436 Installation Instructions

π
H-6436, H-6437
FLUORESCENT
WRAP LIGHTS
TOOLS NEEDED
Phillips Screwdriver Electric Drill
WARNING!
• Risk of personal injury. Read and follow all warnings and installation instructions. Keep or provide to owner
for future reference.
• Risk of cuts. Wear gloves to prevent cuts or abrasions when removing from carton, handling, installing and
maintaining this product.
• Risk of electric shock. This product must be installed in accordance with the applicable installation code
by a person familiar with the construction and operation of the product and hazards involved.
• Risk of Fire. Minimum 194°F supply conductors. Consult a qualified electrician to ensure correct branch
circuit conductor.
1. Remove diffuser from housing by sliding diffuser to
one side; then, lift opposite side over flange.
(See Figure 1)
Figure 1
2. Remove wireway cover from housing by squeezing
wireway cover to disengage from retaining slots.
(See Figure 2)
Figure 2
PAGE 1 OF 2
1-800-295-5510
uline.com
Pliers
Hammer
INSTALLATION
Flathead Screwdriver
3. With power off, remove knockout from center of
fixture housing. Place standard screwdriver on
center of slot and gently strike with hammer.
(See Figure 3) Grip edge with pliers and flex back
and forth until removed.
Figure 3
4. Lift fixture housing to ceiling, centering knockout
over outlet box and parallel to walls. Mark ceiling
with pencil for mounting holes through 1/4 x 3/8" slots.
Drill 1/8" pilot hole at each location. If drill does not
encounter ceiling joist, enlarge hole in ceiling to
accommodate toggle bolt. (See Figure 4)
Figure 4
0117 IH-6436