Advertisement
5. With power off, hold fixture up to outlet box and pull
wires into fixture housing through the knockout hole.
(See Figure 5)
Figure 5
6. Secure fixture housing at each end to ceiling with
#10 wood screws or toggle bolts, depending on
structural conditions. (See Figure 6)
Figure 6
7.
With power off, make power supply connections.
Attach ground wire to green ground screw; then,
connect supply wires, black to black and white to
white with wire nuts. (See Figure 7)
Figure 7
π
CHICAGO • ATLANTA • DALLAS • LOS ANGELES • MINNEAPOLIS • NYC/PHILA • SEATTLE • MEXICO • CANADA
PAGE 2 OF 2
INSTALLATION CONTINUED
8. Replace wireway cover tabs in fixture housing. Make
9. Install lamps, insert pins of the T8 linear lamp into
10. Install diffuser by hooking one side of diffuser on
1-800-295-5510
uline.com
sure no wiring is pinched under cover. (See Figure 8)
Figure 8
sockets and rotate 90°. (See Figure 9)
Figure 9
housing flange and carefully shifting opposite side
over housing flange. Then, lift other side of fixture
housing edge as shown. (See Figure 10)
Figure 10
90° Mark
0117 IH-6436
Advertisement
