CONTROL PANEL OPERATION PICEM75 SMALL LARGE WATER ON/OFF Display Explanation There is not enough water in the water reservoir, add more water. Ice making is in progress. If there is an “S” at the top right side of the symbol, the machine is making small ice.
Page 4
OPERATING IN STRUCTIONS Step 1: Plug the machine into an outlet. Step 2: Open the water reservoir access door and add water as shown in sketch A. You can also add water automatically by connecting the unit to a water source as shown in sketch B. Sketch A Sketch B Add Water Manually...
Page 5
Step 7: Once the ice making cycle is nished, the water tray will tilt forward and the remaining water will ow back into the water reservoir, and then the ice cubes will drop from the ngers. Step 8 In about 15-35 seconds, the water tray will tilt backward and the ice produced in the previous cycle will be pushed to the ice reservoir directly.
SAFETY NOTICE In order to avoid any accidents, please refer to the following: 1. Disconnect power before servicing. 2. Do not pull directly on the wire when plugging or unplugging the unit. 3. If ice is abnormal, please call the seller. 4.
TROUBLESHOOTING 1. Please note, if a power failure occurs due to disconnection of the power cord, or the o power button has been pushed o during an ice making cycle, then small ice chips may form and lodge in the automatic shovel causing it to jam.