Adjusting The Volume; Turning Off The Power - Toshiba TDP-ET10 Owner's Manual

Basic operations (Continued)

Adjusting the volume

8
The speaker volume can be adjusted by pressing [-] [+] key on control panel or remote
control.

Turning off the power

9
Turn off the power by following the instruction in "Turning the power off" in
■ Note
• Note that a lamp characteristics may rarely cause the brightness to fl uctuate slightly.
• A lamp is consumable item. If used for extended periods, images will appear dark,
and the lamp could burn out. This is characteristic of a lamp, and is not malfunction.
(The lifetime of the lamp depends on conditions of use.)
TM
• The DMD
spots (pixels that do not light) or bright spots (pixels that are constantly lit) on the
panel. Please note that these are not malfunctions.
• Although this projector supports a wide range of RGB signals, any resolutions not
supported by this projector (WVGA) will be expanded or shrunk, which will affect
image quality slightly. To view high-quality images, it is recommended that the com-
puter's external output should be set to WVGA (854 × 480) resolution.
• With some models of computer having LCD displays or the like, displaying images si-
multaneously on the projector and the monitor's display may prevent the images from
displaying properly. If this happens, turn off the computer's LCD display. For informa-
tion on how to turn off the LCD display, see the owner's manual of your computer.
• If a signal not supported by the projector is input, the "Unsupported signal" will ap-
pear.
• If no signal is being input from the connected device, the "No signal" will appear.
is made using extremely advanced technology, but there may be black
30
p.27
.