Adding Channels To The Tv's Memory; Programming Channels Automatically; Adding And Erasing Channels Manually - Toshiba 43H72 Owner's Manual

Adding channels to the TV's memory

When you press Channel y or z, your TV will stop only on the
channels stored in the TV's channel memory.
Follow the steps below and on the next page to program all active
channels into the TV's memory.

Programming channels automatically

Your TV can automatically detect all active channels in your area and
store them in its memory. After the channels are stored automatically,
you can manually add or erase individual channels (see page 22).
To program channels automatically:
1. Press MENU, and then press x or • until the SET UP menu
appears.
2. Press y or z until the TV/CABLE is highlighted.
3. Press x or • to highlight either TV or CABLE, depending on
which you use. If you use an antenna, highlight TV; if you use
cable, highlight CABLE.
SET UP
LANGUAGE ENGL SH I
CLOCK SET 0 0 : 0 0
ANT 1 / 2 ANT1
TV / CABLE TV / CABLE
CH PROGRAM
ADD / ERASE ADD
QU I CK CONNECT GU I DE
4. Press z to select CH PROGRAM.
SET UP
LANGUAGE ENGL SH I
CLOCK SET 0 0 : 0 0
ANT 1 / 2 ANT1
TV / CABLE CABLE
CH PROGRAM
ADD / ERASE ADD
QU I CK CONNECT GU I DE
5. Press x or • to start channel programming. The TV will
automatically cycle through all the TV or Cable channels
(depending on which you selected), and store all active channels
in the channel memory.
While the TV is cycling through the channels, the message
"Programming Now—Please Wait" appears.
6. When channel programming is complete, the message
"Completed" appears.
7. Press Channel y or z to view the programmed channels.

Adding and erasing channels manually

After you have programmed the channels automatically, you can
manually add or erase specific channels.
To add or erase channels manually:
1. Select the channel you want to add or erase. If you are adding a
channel, you must select the channel using the Channel Number
buttons.
2. Press MENU, and then press x or • until the SET UP menu
appears.
(continued on next page)
Note:
To tune the TV to a channel not programmed
in the channel memory, you must use the
Channel Number buttons on the remote
control.
LIGHT RECALL POWER
TV
CABLE
MUTE TV/VIDEO TIMER
VCR
1 2 3
Channel yz
CH
4 5 6
7 8 9
VOL
CH RTN
0
100
ENT
ADV/
PIP CH
MENU
MENU/
FAV FAV
ENTER
yzx •
ADV/
PIP CH
STOP SOURCE PLAY PIP
REC TV/VCR REW FF
STILL LOCATE SWAP
21