Toshiba SATELLITE A200 Maintenance Manual page 168

4 Replacement Procedures
3. Remove the speakers.
Figure 4-60 Removing the speakers
Installing the Speakers
To install the speakers, follow the steps below and refer to the figures in the preceding section.
1. Seat the speaker brackets in the top cover paying attention to the direction markings.
2. Replace the speakers and secure with three M2.5x4 screws on each side.
3. Thread the right speaker cable through the top cover.
4. Turn over and install the top cover onto the system board.
5. Connect the speaker cables (black and red) to the system board.
4-50 Minnesota 10M/10MG Series Maintenance Manual