Table of Contents
Advertisement
2.1.5.1 First Card
1. Press 1, 2, and 3 keys. Machine performs punch cycles
but does not escape from column1.
2. Press error reset key.
3. Press left-zero key. Three zeros are punched, but only
the last one is printed.
4. Press skip key. Cards skip to column 34.
5. Backspace to column 14 to check that registration is
maintained for 20 columns of backspacing.
6. Press dash key. If machine has X-skip feature, program
drum skips to column 34; if not, press skip key and
program drum skips to column 34.
7. Press A through Z keys.
. Press skip key to move card to column 80.
9. Multipunch O through 9. Multipunch key must—be
pressed and held while keying-in 0 through 9.
2.1.5.2 Second through Fifth Cards
1. Set auto skip/dup switch to on position.
2. Set left-zero print switch to on position.
3. Press 7 and 9 keys.
4. Press left-zero key. The 0, 7, and 9 are punched and
printed, and machine skips and duplicates to column 80.
5. Press space key.
2.1.5.3 Sixth Card
. Set auto skip/dup switch to on position.
Set program select switch to TWO.
Press program two key.
Press 1, 2,3, and dash Keys.
a.
A 1 and 2 are punched and printed in columns 1
and 2.
b.
A 3 and dash are punched andprinted in column 3
(a dash is an 11-hole).
5. Press 1, 2, 3, 4, and left-zero keys. A 1, 2,3, and 4 are
punched andprinted.
Press 1, 2,3, 4,5, and left-zero keys.
Press 1 through 6 andleft-zero keys.
Press 1 through 7 andleft-zero keys.
Press 1 through 8 andleft-zero keys.
Press dup key. Machine duplicates to column 60.
11. Press skip key. Program drum skips to column 78.
12. Hold alpha key andpress Z, A, and Q keys.
2.1.5.4 Seventh Card
1. Set auto skip/dup switch to on position.
2. Repeat steps 4 through 9 of 2.1.5.3. Machine auto-
matically duplicates and skips the remainder ofthe card.
2.1.5.5 Eighth Card
1. Press program onekey.
2. Press 7, 9, and left-zero keys. The 0,7, and 9 are punched
and machine duplicates and skips to column 80.
3. Operate clear switch. The three remaining cards should
feed to the stacker.
2.1.6 Final Checkout
Operator should set up and test machine using a practical
application.
Section 2. Features
2.2 INSTALLATION PROCEDURES
2.2.1 Feature Checkout
Refer to Field Engineering Theory—Maintenance, JBM 29
Card Punch Features/29 Interpreting Card Punch, Model C,
Form 223-2926. Set up and check out the special features
according to the feature description.
Note: Perform the installation procedure for the basic unit
model before checking the features. For Model C machines,
use procedure for Model A machines.
2.2.2 Final Checkout
Operator should set up and test machine using a practical
application.
29 FEMM
(4/69)
2-3
Advertisement
Table of Contents
